Download the TDS and MSDS for our 1100 H18 aluminum entry board — both document numbers, revisions and the applicable grade are listed below so you can file them against a quotation or a first-article record.
The YUESHAN aluminum entry board technical data sheet applies to the 1100 H18 aluminum entry board supplied at 0.18 ± 0.015 mm. It is a two-page PDF you can download directly from this page, with no form or registration. File it against a quotation, an incoming-inspection record or a first-article submission. The material safety data sheet is published as MSDS-AL-2026-01, Revision 1.0, dated 2026-07-20, and downloads from the same section below. Any third-party test reports are separate documents supplied on request.
This page is the download point for two documents: the technical data sheet and the material safety data sheet covering our 1100 H18 aluminum entry board. It exists so that each document has a stable, linkable home — a PDF on its own cannot be indexed, quoted with context or cited by a colleague without a page that explains what it is and which grade it applies to.
| Document | Applies to | Revision | Format | |
|---|---|---|---|---|
| Aluminum Entry Board TDS PDF, direct download |
1100 H18 aluminum entry board, 0.18 ± 0.015 mm | Rev 1.0 2026-07-20 |
PDF, 2 pages | Download TDS |
| Aluminum Entry Board MSDS Doc no. MSDS-AL-2026-01 |
1100 H18 aluminum entry board, 0.18 ± 0.015 mm | Rev 1.0 2026-07-20 |
PDF, 1 page | Download MSDS |
No form, account or email address is required. Both files are served from this domain and the links above are the canonical download points for these revisions.
The document is a product specification sheet. It states the properties a buyer needs in order to qualify the material against an incoming-inspection plan:
The material safety data sheet covers the same grade from a handling and safety standpoint:
The sheet covers the 1100 H18 aluminum entry board — a full-hard, non-heat-treatable 1100-series sheet used as the entry layer at the top of a drilling stack. It is the plain (uncoated) entry board, not the coated or lubricated variants. For those, see:
If your question is which entry board to use rather than what its specification says, start at the selection guide.
Being explicit about scope matters more on a download page than anywhere else, because a specification sheet is often read as if it certifies more than it does.
For traceability, reference the document by number and revision rather than by file name, and pin the revision you qualified against. If a revision changes, the values in your qualification file should be re-confirmed rather than assumed to carry over.
| Field | Value |
|---|---|
| Document | Aluminum Entry Board TDS |
| Revision | Current revision at download |
| Revision date | 2026-07-20 |
| Issuing scope | 1100 H18 aluminum entry board |
| Pages | 2 |
No. The download link on this page is direct — no form, account or email address required.
Yes. Ask for it with your quotation or sample request and we will attach the current revision, so the specification you are quoting against and the one you receive match.
It downloads directly from this page as MSDS-AL-2026-01, with no form or registration. If you need a version issued in a specific format or language for your destination country, ask us and we will supply it.
Treat a revision change as a change notification. Re-confirm the values your qualification file depends on, particularly gauge tolerance and flatness, rather than assuming continuity across revisions.
Document sets for those product lines are released progressively. Ask for the current status when you request a quotation and we will tell you exactly what exists for the grade you need.
Send the grade, the document type you need and your destination country, and we will reply with the applicable revision.